The debugging method of fully automatic dispensing machine mainly includes the following steps:
Install the fixing frame: Before using the fully automatic dispensing machine, you need to install the fixing frame to fix the dispensing machine on the workbench.
Turn on the air pressure and power supply: Make sure that the air pressure and power supply are working properly, and fix the hose.
Programming: Prepare the program according to the product dispensing graphics, set the dispensing speed, the relative value of the z-axis height increase, the dispensing time parameters, etc.
Set the reference point: Enter setup, select the reference point and record it to ensure that the needle is at the reference point. If the needle changes, correct the reference point by adjusting the X, Y, and Z axes.
Air pressure setting: Set the corresponding air pressure according to the viscosity of the glue to ensure the stability of the glue output and dispensing speed.
Check each component: Before debugging, check whether the power supply, transmission system, control system and other components are working properly.
